Rock Crawler Street Class Registration and Information
What has been called the best man made rock crawl course in New England, put your crawler to the test and try to do it the fastest. The course is built and ran by crawling enthusiasts who want to have just as much fun as the competitors!
Rock Crawl Street Class:
Street Class Rules ans Regulations:
Same size and type
measurements (height & width) must
conform to OEM specifications for proclaimed vehicle. Body and frame must match
(example: claimed YJ, body and frame must both be YJ).
The brake pedal on
the floor must operate all brakes.
Brakes must be in
good working condition with adequate pads. Brakes that are worn out or oil
soaked will not pass.
Brake lines must
be in good shape without leaks and ran in a safe route from cylinders to
Master and slave
cylinders must be in good shape without leaks. Adequate braking resistance at
the pedal is required.
Radiator must be
in the factory position and covered so that, in the event of a break in the
radiator or hoses, spectators, spotters and drivers are protected from the
coolant spray and spill.
Radiators must be
have an OEM or adequate sized aftermarket overflow bottle, securely mounted,
and connected to the radiator by an overflow tube. Overflow bottles may not be
mounted over or in the passenger compartment. Overflow bottles may not be
Batteries must be
in good shape with adequate mounting to keep the battery in place in the event
of a roll.
Wires must be in a
condition and position that is safe. Exposed or burned wires are not approved.
1. All engine sizes
and configurations are approved.
Alcohol is not
approved for competition as a main fuel (see above).
Fuel lines must be
free of leaks or cracks in hoses.
assemblies must be in good order and work smoothly. Throttles that do not move
smoothly throughout their entire range of motion will not pass.
1. Only OEM frames
Factory seats must
be fastened to the tub in the factory mounting points or to the roll cage.
must be in good condition without rust or corrosion
Seat belts must be worn at all times by everyone is vehicle well on fairgrounds.
steering is not permitted.
components, u-joints, and fittings must be in good working order as determined
by Northeast Performance Diesel.
configuration must be maintained. Crossover and high steer are allowed.
points, connecting points must be free of cracks and in good physical condition
as determined by Northeast Performance Diesel.
Tire size limit is no bigger than 36" or the metric equivalent, by sidewall designation.
screws, or anything added to the tire to aid traction will not be permitted.
Wheels must be
mounted onto the axle with minimum of five lug studs.
All lug studs must
have the proper nuts on them.
built and sold electric, hydraulic, and power take off winches, with a minimum
capacity of 5000 pounds on the first
wrap of cable, are acceptable.
Rope/Cable must be
in acceptable condition with minimal fraying or kinks.
Winch must be
mounted using all factory-mounting positions on either the bottom or front and
Must be in working
1. Seat belts must be
worn at all times while driving or riding in a vehicle during an event.
All items must be
securely fastened to prevent injury in the event of a rollover. Coolers,
miscellaneous parts, and other extraneous items are to be removed from the
vehicle prior to each obstacle.
full fire extinguisher must be mounted. Extinguisher should not be mounted
close enough to fuel cells or potential fire hazard areas that would make it
dangerous to obtain.
1. All competitors
riding in a vehicle must wear a DOT/Snell approved helmet while competing.
1. Any competitor
(driver or spotter) must report any injury to Northeast Performance Diesel
prior to leaving the premises.
Drugs and alcohol
will not be permitted in any degree during competition. Competitors who are
found to be consuming or are under the influence of drugs or alcohol during
competition will be disqualified from the event they are participating in.